本平台为互联网非涉密平台,严禁处理、传输国家秘密或工作秘密

加热状态下烟草原料水分生成特性分析

Analysis of moisture generation characteristics of tobacco materials under heating conditions

  • 摘要: 为探究加热状态下烟草原料的水分生成特性,利用热重-质谱联用法和加热炉-卡尔·费休库伦法,比较分析了6种组分(纤维素、半纤维素模化物、果胶、淀粉、葡萄糖、果糖)和烟草原料的热行为与热裂解水分生成规律,并定量分析了烟草样品在不同温度区段的水分生成量。结果表明:①果糖发生热裂解脱水的起始温度比葡萄糖低大约35~45 ℃,半纤维素模化物热裂解生成水分的过程温度范围比纤维素更宽,果胶发生热裂解脱水的起始温度比淀粉低大约30~40 ℃。②烟草原料在加热过程中会持续不断地生成水分,烤烟在150~255、255~335、335~390 ℃温度区间分别存在3个热裂解水分析出峰,烤烟在160~235 ℃温度区间比白肋烟分别多了一个热失重峰和水分析出峰,辊压法再造烟叶在200~330 ℃温度范围内的热失重速率和水分析出曲线的波动变化幅度均较为平缓。③烟草样品在100~280 ℃受热阶段的水分释放量在总水分生成量(30~280 ℃)中的比例可高达50%左右;烤烟和香料烟的水分生成量在100~280 ℃温度区间呈先增加后减少再增加的趋势;白肋烟的水分生成量在100~220 ℃温度区间呈先增加再缓慢变化的趋势,在220~280 ℃温度阶段呈先增加后减少的趋势;辊压法再造烟叶的水分生成量在100~220 ℃区间呈先减少后增加的趋势,在220~280 ℃范围内的波动变化幅度较小。

     

    Abstract: To investigate the moisture generation characteristics of tobacco materials under heating conditions, the pyrolysis behavior and the moisture generation trends by selected tobacco materials (laminar and reconstituted tobacco materials) and six components (cellulose, hemicellulose model compound, pectin, starch, glucose, fructose) were comparatively studied by thermogravimetric-mass spectrometry and heating furnace-Karl Fischer coulometry. The amounts of moisture generated by tobacco samples at different temperature ranges were quantified. The results showed that: 1) The initial temperatures for fructose pyrolysis and dehydration were about 35-45 ℃ lower than those for glucose. The temperature ranges of pyrolysis and dehydration of the hemicellulose model compound were wider than those of cellulose. Pectin showed a 30-40 ℃ lower initial temperature for pyrolysis and dehydration compared to starch. 2) Tobacco materials could continuously generate moisture during heating. There were three separate pyrolytic moisture peaks for the flue-cured tobacco sample in the ranges of 150-255, 255-335 and 335-390 ℃. The flue-cured tobacco sample had additional thermogravimetric and moisture release peaks at 160-235 ℃ compared to the burley tobacco sample. The fluctuation characteristics of the derivative thermogravimetric curve and moisture release curve for the rolling processed reconstituted tobacco material at 200-330 ℃ were both milder. 3) The proportions of moisture generated by the tobacco samples at 100-280 ℃ to the total amount of moisture generated at 30-280 ℃ reached up to about 50%. The amounts of moisture generated by the flue-cured tobacco and oriental tobacco at 100-280 ℃ first increased, then decreased and increased again; that by the burley tobacco showed an increasing trend followed by a steady stage at 100-220 ℃ and an increasing trend followed by a decreasing trend at 220-280 ℃; and that by rolling processed reconstituted tobacco exhibited a decreasing trend followed by an increasing trend at 100-220 ℃ and a gentle fluctuation trend at 220-280 ℃.

     

/

返回文章
返回